Recently launched on the "washing machine noise" of the prize investigation, so far, 71% of my friends that the family too much noise in the washing machine, washing machine noise problem seems to have become the concern of consumers to use one of the washing machine.
The problem is not the product itself that aside, cast bronze I today have invited experts to address how we will solve the problem caused by improper operation of the washing machine noise is large, bronze bushing the family washing machine Chao Siren's friends up to look at it.
Noise causes.
1. Washing machine installation injustice;
2. Motor bearings or the shaft with bearings badly worn or broken;
3. Drum belt too tight;
4. dry bushing Pulsator washing barrels at the end of deformation and friction;
5. Dehydration barrel touch outside the box;
6. Tight seal on the shaft;
7. Automatic balancing set of drums boom out of balance washing machine and so on.
Expert Weapon governance noise.
Washing machine after prolonged use,plain bearing due to mechanical wear and tear, lack of lubricating oil, machine aging, spring fatigue deformation and other reasons, there will be a variety of abnormal vibration and noise. If timely repair, washing machine parts will lead to accelerated wear and even damage.sleeve bushing In fact, by appropriate adjustment and simple repairs,DU bushing which can eliminate or reduce the vibration and noise.
1, the laundry, the body issued a "pop" sound. The fault is a laundry bucket and cover many collision between the washing machine or placed on the ground is not flat or four feet is not good contact with the ground. bushing At this time the focus needs to adjust the washing machine, place a smooth, or pads on the bottom right of the four blocks.
2,brass bushing the laundry, the impeller rotating issued a "giggle" friction sound. Maintenance, can be placed in the water, hold clothing to be checked. At this point, if the impeller rotates, there is still "giggle" friction sound,Mould guide plate that is due to impeller rotation and the bottom of laundry bucket caused by friction, such as clothing and then into, the sound will be even greater. Failure may be due to impeller screw loose, can now remove the impeller, and then padded the bottom of the shaft washer of proper thickness to increase the impeller and the barrels at the end of the gap. plastic bushing Elimination of collision or friction between the two. If the impeller outer grazing laundry bucket, you should remove the impeller, renovated and then installed.
3, the motor rotates, the rotating belt issue a "crackling" sound. The fault is due to relaxation caused by the drive belt. Maintenance, can be the motor base of the fastening screws loosen, the motor shaft away from the wave direction of rotation, so that the drive belt tension, then the base of the fastening screws tightened.