"October" holiday in close proximity, travel by car has become an essential item of car owners. Before travel, repair and maintenance is essential before the holiday. Your car in good condition, only allow a smooth and convenient travel by car, more car owners to ensure their personal safety. Here, Automotive repair and maintenance network, the majority of owners are sent to the maintenance of leave before dinner. DU bushing The features: to maintain the integration and maintenance!
Leave before the service
How to deal with car car driving emergency breakdown
1, forward, the water hose rupture
Breakdown is Mould guide plate not available when the fabric coated with a layer of soap will be strapped up leaks; such as rupture of large, ruptured hose can be cut off, put in the middle of a bamboo or iron pipe, and tie tightly with wire. Automotive repair and maintenance network
2, broken fan belt
To the broken belt or using iron Sizha good way to open to open the stop the car drove away.
3, screw slipping
Screw will result in spills or slipping loose link, it does not work. Then the original screw with a hammer can hammer flat to increase expansion on both sides and then fasten good,plasic bushing but not many demolition, repair until the next maintenance time.
4, fuel tank damage
Motor vehicles in use, found that leak from the tank, oil spills can be wiped clean place, coated with soap or bubble gum at the oil spill, temporarily blocked; with epoxy adhesive patches, the better.
Brake failure causes and failure to determine and exclude
1, failure phenomenon
Brake pedal travel is too large, slow braking action, brake performance is very low or even loss of braking distance increase.
2 Failure
1) brake oil pressure is insufficient. plain bearing (Brake master cylinder oil, brake pipe rupture, leaking pipe joints, oil plug)
2) The air brake system
3) brake pedal free travel or brake gap is too large, the brake shoe lining is bad, badly worn or oil
4) brake master cylinder, brass bushing wheel cylinder piston and the cylinder tube wear and tear or injury, damage to the aging cup
Leave before maintenance
Use and maintenance of three turbo engine tips
1, not the car left
After engine start, especially in winter, should be allowed to idle for some time, so before the turbocharger rotor at high speed sufficient to oil lubricated bearings. So, just after the start must not Meng throttle to prevent damage to the turbocharger oil seal.
2, do not turn off immediately